Clearing factor

From The Right Wiki
Revision as of 15:27, 3 July 2024 by imported>Ike9898 (External links: I think this category fits and the one I deleted don't; this article is not about a technique)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

In centrifugation the clearing factor or k factor represents the relative pelleting efficiency of a given centrifuge rotor at maximum rotation speed. It can be used to estimate the time t (in hours) required for sedimentation of a fraction with a known sedimentation coefficient s (in svedbergs):

t=ks

The value of the clearing factor depends on the maximum angular velocity ω of a centrifuge (in rad/s) and the minimum and maximum radius r of the rotor:

k=ln(rmax/rmin)ω2×10133600

As the rotational speed of a centrifuge is usually specified in RPM, the following formula is often used for convenience:[1]

k=2.53105×ln(rmax/rmin)(RPM/1000)2

Centrifuge manufacturers usually specify the minimum, maximum and average radius of a rotor, as well as the k factor of a centrifuge-rotor combination. For runs with a rotational speed lower than the maximum rotor-speed, the k factor has to be adjusted:

kadj=k(maximum rotor-speedactual rotor-speed)2

The K-factor is related to the sedimentation coefficient S by the formula: T=KS Where T is the time to pellet a certain particle in hours. Since S is a constant for a certain particle, this relationship can be used to interconvert between different rotors. T1K1=T2K2 Where T1 is the time to pellet in one rotor, and K1 is the K-factor of that rotor. K2 is the K-factor of the other rotor, and T2, the time to pellet in the other rotor, can be calculated. In this manner, one does not need access to the exact rotor cited in a protocol, as long as the K-factor can be calculated. Many online calculators are available to perform the calculations for common rotors.

References

External links